This dividing head is a revised model with new design. In Comparison with old model FW universal dividing head the new model has a good looking and is available to carry out indexing for any desired angles otherwise, a face plate can be directly mounted onto the spindle nose.
This dividing head is one of accessories for milling machine. It can help the maching in dividing the workpieces held between two centers or on a chuck into any desired angles. With the help of it, grooves; slots; gears; helical gears; Archimedes cams and helical curves can be finished on the machines.
ACCESSORIES:
(1):Tailstock  (2):Gear bracket  (3): Change gear   (4):Jack Center  (5): Carrier
(6)Hole plate  (7): Flange   (8):Vernier dial   (9): 3-jaw chuck  (10): Face plate (Specially ordered)
Type		FW80	F11 100A	F11 125A	F11 160A
Center height		80/3.15	100/3.94	125/4.92	160/6.30
Tilting angle of the spindle		≥95º ;  ≥5º
Rotating angle of the spindle for one complete revolution of the dividing handle		9º
Min. value of the vernier		10"
Worm gear ratio		01:40
Diameter of spindle register taper		Φ36.541/Φ1.441	Φ41.275/Φ1.63	Φ53.975/Φ2.13
Spindle taper bore (Morse)		MT  NO.3		MT NO.4
Width of the locating key		14/0.55		18/0.71
Hole No. of hole plate	first face	24,25,28,30,34,37,38,39,41,42,43
	second face	46,47,49,51,53,54,57,58,59,62,66
Module of change gears		1.5/0.06		2/0.08
Teeth No. of change gears		25,25,30,35,40,50,55,60,70,80,90,100
Individual indexing error of the spindle for one complete revolution of dividing handle		60"	±45"
Accumulative indexing error in any each of the four quadrants		±1'